The Ignite line of liquid fluorescent colorants is compatible with Smooth-On urethane rubbers, urethane plastics, urethane foams (rigid and flexible) and silicones. The fluorescent or "glow" effect is maximized under ultra-violet light or "black light." The most dramatic color effect is realized when an Ignite colorant is used with a clear or translucent urethane rubber (such as Clear Flex 50) or plastic (such as Smooth-Cast 325).
The NEW Ignite 9 pack gives you the opportunity to experience each color without spending a lot of money.
What Makes Castings Made With Ignite Pigments Appear To Glow? When you add Ignite fluorescent color to a urethane material, more ultraviolet light from the cured material is visible to your eye vs. castings made with SO Strong colorants. The casting appears brighter in ambient light and appears to glow under ultraviolet light.
Technical bulletin Ignite Fluorescent colors
To get you started, we offer the following colorant loading levels. Results may vary.
By Weight Using A Gram Scale: Add Ignite colorant at a ratio of between 0.5% - 1.5% of the total weight (Parts A + B mixed) of the material being cast. 1% pigment yields the best results. Adding more than 1.5% by weight offers no benefit and is a waste of the colorant. Too much colorant may cause cure inhibition.
By Volume Measured In Drops: Add 30 drops of Ignite per 3 oz (88 ml) of mixed urethane material. If using a translucent material (like Smooth-Cast 325) you can use 15 drops to maintain translucency of the material.
Pre-Mix Before Using: Ignite colorants are pigment dispersions and may separate over time. They must be thoroughly pre-mixed in the container before using with a liquid urethane product.
Directions For Use: After dispensing the required amount of urethane material Parts A and B into measuring containers, add colorant to Part B and mix thoroughly. Combine Parts A and B into a mixing container and mix as directed by the urethane product technical bulletin. Blending Colors - You can combine different colors on a pallete to create a custom color before adding to liquid urethane product as directed above.
There are no issues when using this product with urethane rubbers, plastics and foams or tin-catalyzed silicones. However Ignite pigments will drastically thicken platinum silicone rubber. Adding Ignite colorants to a Smooth-On platinum cure silicone such as Dragon Skin will make the silicone notably thicker, thereby affecting its ability to be vacuum degassed. Recommended loading maximum is 1% Ignite pigment by weight. An option for using Ignite colorants with a platinum silicone may be to use pigmented material as paint for brushing on to an existing platinum silicone casting or appliance. You can use Ignite colorants with our Psycho Paint system.
Smooth-On offers this color guide as a general reference only and assumes no responsibility for color accuracy or matching. Results will vary from one material to another. The end user is solely responsible for determining color suitability and accuracy. Small scale testing is recommended. User determines amount to add; If this is your first time adding color tint or pigment to a urethane, epoxy or silicone system, you may want to test the color effect by adding a few drops to a small amount of urethane material and observe the outcome. It may take a few test castings to attain the desired color outcome.
Looking for a clear fluorescent additive? Cryptolyte is a clear additive that can be added to urethane or silicone materials that will cause cured material to glow a bright blue when exposed to UV light (black light).