SuperSeal was developed as an economical, fast-drying sealing agent for a variety of porous surfaces including gypsum plasters, concrete and wood. This sealing agent will quickly and effectively seal surfaces without interfering with surface detail. The new formula offers better performance and faster evaporation. Mold rubber (polyurethane, silicone or polysulfide) can then be applied.
Superseal
Superseal_
Features
Low Cost
Low Viscosity wets out well over any surface
Evaporates Quickly
Ultra Thin Film does not interfere with reproduction of surface detail or finish
Gives cured rubber mold surface a smooth, satin finish
Removable can be rinsed from model surface with warm water
Transport Regulated Goods
The transport of items out of this group can be restricted due to EU restrictions and regulations and will require a specialized carrier. Transport costs will not be automatically calculated. We will give you transport options and a quote later. Preparing this order for transport will not fit within our normal time frame and delivery may take a few days longer.
Instructions
Safety - CONTENTS FLAMMABLE: Keep product away from flame and all ignition sources. Use in a properly ventilated area ("room size ventilation). Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.
Store and use material at room temperature (73 F/23 C). This product has a limited shelf life and should be used as soon as possible.
NOTE: ALWAYS SHAKE WELL BEFORE USING
A minimum of 2 coats of SuperSeal is recommended to seal most surfaces. For extremely porous surfaces (i.e. limestone or dry plaster) an additional coat of SuperSeal may be required. Or apply two coats of SuperSeal and follow with an application of Ease Release 200. Superseal can be applied using a soft brush or a non-aerosol spray bottle to lightly mist SuperSeal onto model.
Apply a thorough thin coating of SuperSeal over entire model surface and surrounding forms including intricate detail and undercuts. Compressed air or a hair dryer may be used to blow off any excess that has pooled. Let dry for 5 minutes.
Repeat above 1 - 2 more times and let final coat dry for at least 1 hour.
If recommended by mold rubber manufacturer, apply a light mist coating of release agent (i.e. Ease Release 200). Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.
Important: Discoloration of model surface may occur. If compatibility between SuperSeal and model surface or SuperSeal and a particular mold rubber is a concern, a small-scale test should be made on an identical surface prior to use.